EPSON STYLUS COLOR 760 ESC P 2 DRIVER

Select the misalined dot size By selecting the misalined dot size, following input menu for the adjustment value is displayed. The printed character side of and stick it inside the printed circled line on the PF Loop scale. Lubrication Point continued No. If any ID is not written correctly, it results in white or color lines and also gives bad influence on dot weight. Fix the right and left Parallelism adjustment bushings with screws.

Uploader: Vujas
Date Added: 14 July 2006
File Size: 35.63 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 31580
Price: Free* [*Free Regsitration Required]

Epson Stylus Color 760 – printer – color – ink-jet Series

Action If a trapezoid waveform is not output in the previous step, check all the power transistors Q3 – Q4 for base waveform. Remove the Upper Housing. Comments to this Manuals Your Name. Don’t show me this message again. Then remove it from the left side hole the ASF Frame. Outputs the common voltage To check if each pair transistor is working properly, check the trapezoid waveform at the emittor terminal of the charging side.

Right of theTop Frame Notch portion Figure If the backlash value is too narrow, move the PF motor to front side of the printer a little by pulling the PF motor.

  CREATIVE BROADBAND BLASTER 8015U DRIVER DOWNLOAD

Hook portion for Compression Spring Figure The paper in use is longer than specified. When the printer is initialized or returned to the idle state, the parallel interface gets into the ready state.

With the PG lever set front gap is small and then rear, move the carriage right and left and make sure that the thickness gauge does not move for the both settings. Apply the value for the most properly aligned pattern in the Bi-D adjustment pattern print.

The following menu appears. If the backlash value is too wide, move sytlus PF motor to the rear side of the printer a little by pushing the PF motor.

Port Confirmation Menu A If the NPN contact transistor is colorr, the findings should be as shown under the figure. Removing the Paper Guide Front Figure Lift up and remove the Upper Housing, pulling it forward. Epson printer accessories – ink cartridge user manual 4 pages. Clear the protection counter vaiuse Now clearing the protection counter.

Epson Stylus Color – printer – color – ink-jet Overview – CNET

Is the transformer T1 broken? In case the securing torque is over 6kg-cm, the PF motor may be broken or paper feed accuracy is lowered. This epeon gives information on connectors and their pin assignment. If the thickness gauge does not move, go back to Step 1 and repeat the adjustment.

  MARINO FRANCHITTI RACING DRIVER DOWNLOAD

If you perform these steps when both ink out lights are off, the printer cleans the print heads as described on page 9.

In order to cancel the above menu, select another menu or adjustment item. The basic home volor detection sequence is as described below: Make sure the printer is turned on. Looking for a tech gift that’s not too expensive?

Epson Stylus Color Esc P 2 Driver Download

Laptops by Dan Ackerman Nov 26, Printer units Self-test Is the operation normal? Ink cartridge can not be re-filled. Enough ink is remaining in the cartridge, but the printer shows the Ink low or Ink end condition and can not continue to print.

When the adjustment lever is moved up and down, this printhead is maintained tilt in a flexible and adjustable structure by the tilt adjustment mechanism. This adjustment is required in the following cases. Personal printer – ink-jet – color.